16.2.7 Configure the settings relating to SNMP
The settings relating to SNMP can be configured on this page. It is possible to check the status of the camera
by connecting to the SNMP manager. When using the SNMP function, contact the network administrator.
[Community]
Enter the community name to be monitored.
•
Available number of characters:
0 - 32 characters
•
Default:
None (blank)
IMPORTANT
•
When using the SNMP function, it is necessary to enter the community name. When no community
name is entered, the SNMP function will not work.
[System name]
Enter a system name to be used to manage the camera with the SNMP function.
•
Available number of characters:
0 - 32 characters
•
Default:
None (blank)
[Location]
Enter the name of the location where the camera is installed.
•
Available number of characters:
0 - 32 characters
•
Default:
None (blank)
[Contact]
Enter the E-mail address or the phone number of the SNMP manager.
•
Available number of characters:
0 - 255 characters
•
Default:
None (blank)
16.2.8 Configure the Diffserv settings
The settings relating to Diffserv can be configured on this page. The Diffserv function can be used to set the
priority of image/audio data sent from routers.
The priority set to this function must match the DSCP value configured to the router.
162
Operating Instructions
16 Configuring the network settings [Network]
