Note
•
Depending on the network environment, notification may not be provided in real time.
•
When multiple cameras are using the same “Alarm status reception port”, even if “Real time” is selected
for “Alarm status update mode”, status notification is not provided in real time. In this case, change the
“Alarm status reception port” settings.
[Alarm status reception port]
When selecting “Real time” for “Alarm status update mode”, designate a port number to which the status change
notification is to be sent.
•
Available port number:
1 - 65535
•
Default:
31004
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[Viewer software (nwcv4Ssetup.exe)] - [Automatic installation]
Determine whether or not to install the viewer software from this camera.
•
On:
Installs the viewer software from the camera automatically.
•
Off:
The viewer software cannot be installed from the camera.
•
Default:
On
[Viewer software (nwcv4Ssetup.exe)] - [Smoother live video display on the browser
(buffering)]
Perform settings to display camera images on the viewer software.
•
On:
Images are temporarily stored on the computer and are displayed smoother.
•
Off:
Images are displayed in real-time and are not stored on the computer.
•
Default:
On
IMPORTANT
•
It is impossible to display images and to receive/transmit audio between the camera and the PC when
the viewer software “Network Camera View 4S” is not installed on the PC.
•
The number of the viewer software installations can be checked on the [Upgrade] tab of the
“Maintenance” page.
[Contrast enhancement(RGB:0 to 255)]
Select “On” or “Off” to determine whether or not to enhance the contrast of H.264 images on the “Live” page.
If “On” is selected, the range of RGB signal on display is extended from 16-235 to 0-255.
When there is a bright part in an image, the intensity may be overexposed.
Default:
Off
Note
•
This setting is only available when viewing images on the “Live” page with Internet Explorer.
•
Even if this setting is changed, transmitted image data and data saved on the SD memory card are not
changed.
[Audio/Monitor out]
SFx311
SPW311L
SPW531L
Set the Audio/Monitor output format.
Audio/Monitor
Default:
Audio
Note
•
When “Audio/Monitor out” is set to “Audio”, “Monitor out” cannot be selected.
•
When “Audio mode” is set to anything other than “Off” or “Mic input”, “Audio/Monitor out” cannot be set
to “Monitor”.
52
Operating Instructions
10 Configure the basic settings of the camera [Basic]
