[Alarm deactivation time]
Configure the duration that detections won't be made after an alarm is detected. For example, by using this
function you can prevent E-mail from being sent too often when E-mail notifications are configured to be sent
to cellular phones when an alarm is detected.
5s/ 10s/ 30s/ 1min/ 3min/ 5min/ 10min
Default:
5s
Note
•
The duration that alarm detections are not made can be managed for each type of alarm. For example,
during the time when detections for command alarms are not made, detections for VMD alarm can be
made.
13.2 Configure the settings relating to the alarm
output terminal [Alarm]
SFx311
SFx310
SPN311
SPN310
SPW311L
SPN531
SPW531L
Click the [Alarm] tab on the “Alarm” page. (
The settings relating to the alarm output terminal can be configured in this section.
Alarm output terminal setup
In order to be able to configure “Alarm output terminal setup”, “Alarm output” must be selected for [Terminal
2] of the [Alarm] setting.
[Alarm output trigger]
Select “On” or “Off” to determine whether or not to output the alarm signals to the alarm output terminal when
an alarm is detected.
•
Default:
Off
[SD memory card error]
Select On or Off to determine whether or not to output signals from the alarm output terminal when an error is
detected for the SD memory card.
SD memory card error condition: SD memory card error (write error, read error, etc), Total use time over 6
years, and number of overwrites over 2000 times
•
On:
When an error status is detected, the signals from an alarm output terminal is outputted and the “Alarm
occurrence indication” button on the “Live” page blinks.
•
Off:
Deactivates the warning status detection.
•
Default:
Off
118
Operating Instructions
13 Configure the alarm settings [Alarm]
