1 Monitor images on a PC
The following are descriptions of how to monitor images from the camera on a PC.
1.1 Monitor images from a single camera
1.
Start up the web browser.
2.
Enter the IP address designated using the Panasonic “IP Setting Software” in the address box of the
browser.
•
Example when entering an IPv4 address:
http://URL registered using IPv4 address
http://192.168.0.10/
•
Example when entering an IPv6 address:
http://[URL registered using IPv6 address]
http://[2001:db8::10]/
<Example of IPv4 access>
<Example of IPv6 access>
IMPORTANT
•
When the HTTP port number is changed from “80”, enter “http://IP address of the : (colon)
+ port number” in the address box of the browser. (Example: http://192.168.0.11:8080)
•
When the PC is in a local network, configure the proxy server setting of the web browser (under
[Internet Options...] under [Tools] of the menu bar) to bypass the proxy server for the local address.
Note
•
Refer to page 171 for further information about the case in which “HTTPS” is selected for
“HTTPS” - “Connection” on the [Advanced] tab of the “Network” page (
®
8
Operating Instructions
1 Monitor images on a PC
