11.6.4.1 Register the preset positions
1.
Select a preset position number.
→
The selected preset position number will be displayed in the “Position No” area.
When the selected number has already been registered, the camera will move to the selected preset
position.
2.
Move the camera to the desired direction.
3.
To display the preset ID on the “Live” page, select “On” for “Preset ID” and enter the desired position title
to be displayed.
4.
The settings for “Auto focus” and “Dwell time” can be configured for each position independently.
5.
Click the [Set] button.
6.
The settings for each item such as “Super Dynamic” can be configured for each position independently.
The settings for “Super Dynamic” (Wide dynamic range
SC384
SC384
SW175
SW175
SW174W
SW174W
SW172
SW172
ST165
ST165
ST162
ST162
), “Back light compensation (BLC)” and “Mask area” are updated immediately.
Note
•
When registering the preset position, the camera direction may move slightly.
Position No
[Preset ID]
Select “On” or “Off” to determine whether to enable or disable the preset ID display. This function can be applied
to each preset position.
•
On:
Displays the preset ID.
•
Off:
Does not display the preset ID.
•
Default
: Off
IMPORTANT
•
When “Preset ID (0-9,A-Z)” or “Preset ID” is configured, it is necessary to click the [Set] button to apply
them.
Note
•
When “On” is selected, the entered preset ID will be displayed at the position selected for “OSD
position” on the [Basic] tab of the “Basic” page. (
®
page 55)
[Preset ID (0-9,A-Z)]
Enter the preset ID to be displayed on images. This function can be applied to each preset position.
•
Available number of characters:
0 - 20 characters
•
Available characters:
0-9, A-Z and the following marks. ! " # $ % & ' ( ) * + - , . / ; : = ?
•
Default:
None (blank)
Note
•
The entered preset ID will be displayed next to the preset position number on the pull-down menu.
When “On” is selected for “Preset ID”, the preset ID will be displayed on images.
[Auto focus]
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
Select “Auto” or “Off” to determine whether to enable or disable the auto focus function after the camera has
moved to a preset position. This function can be applied to each preset position.
•
Auto:
The auto focus function will be activated after moving to a preset position.
•
Off:
Does not activate the auto focus function after moving to a preset position.
•
Default:
Off
Operating Instructions
115
11 Configure the settings relating to images and audio [Image/Audio]
