When “Stream(3)” is selected, the settings for “Stream(3)” on the [Image] tab of the “Image” page will
be changed to the settings for “Stream(3) & recording”.
•
When “Stream(1)”, “Stream(2)”, or “Stream(3)” is selected for “Recording format”, the settings of the
following functions may be corrected.
–
When “VBR” is selected for “Transmission priority”, “Frame rate” is set.
–
When “2s”, “3s”, “4s” or “5s” is selected for “Refresh interval”, “1s” is set.
•
The name of the saved file will be given automatically.
•
When “Stream(1)”, “Stream(2)”, or “Stream(3)” is selected for “Recording format”, the number of users
that can access the camera may be reduced.
•
When performing a recording of a stream with a high bit rate on the SD memory card, there may be
cases where live image of the same stream cannot be displayed.
When it is necessary to display the live images of the stream, improve by performing either of the
following.
–
Lower the bit rate of the stream being recorded on the SD memory card.
–
Monitor live images of other stream or JPEG live images.
[Save trigger]
Select a trigger to save images on the SD memory card from the following.
•
Alarm input:
Saves images at an alarm occurrence.
•
Manual:
Saves images manually.
•
Schedule:
Saves images in accordance with the settings for “Schedule” (
®
the “Stream(1)”, “Stream(2)”, or “Stream(3)” images.
•
Default:
Manual
If you have selected “Alarm input” in the [Save trigger], you can select the alarm type from the following:
•
VMD:
Save the image when motion detection occurs.
•
SCD:
Save the image when SCD occurs.
•
Command alarm:
Save the image when a command alarm is entered.
Note
•
To enable alarms to occur, alarm settings must be configured in advance on the [Alarm] tab.
Stream recording(Alarm)
This setting is only available when “Stream(1)”, “Stream(2)”, “Stream(3)” is selected for “Recording format” of
the SD memory card, and “Alarm input” is selected for “Save trigger”.
[Pre alarm (recording) duration]
Determine whether or not to perform the pre alarm recording. Set the duration to save image data on the SD
memory card.
Off/ 1s/ 2s/ 3s/ 4s/ 5s/ 8s/ 10s/ 15s/ 20s/ 25s/ 30s/ 40s/ 50s/ 60s/ 90s/ 120s
•
Default:
Off
Note
•
The available values change depending on the bit rate and image capture size. As the selected bit
rate increases, the available maximum value for the pre alarm duration decreases.
Operating Instructions
59
2 Settings
