Note
•
If the camera is used in Japan, select “Japan”. If the camera is used outside of Japan, select
“Global”. The “Viewnetcam.com” service that is displayed when “Global” is selected cannot be used in
Japan.
[Service]
Select “Viewnetcam.com” or “Off” to determine whether or not to use “Viewnetcam.com”.
After configuring “Viewnetcam.com”, click “Go to Viewnetcam.com Registration page” to display the
registration window for “Viewnetcam.com” in a newly opened window.
Follow the on-screen instructions to register with “Viewnetcam.com”.
Refer to page 151 or the “Viewnetcam.com” website (http://www.viewnetcam.com/) for further information.
•
Default:
Off
Note
•
When the “DDNS” setting is changed, the “DDNS” setting on the [Advanced] tab of the “Network” page
also changes to the same setting.
[Recommended network setting for internet]
The recommended settings for connecting to the Internet are performed here.
By clicking the [Set] button, a dialog displaying how the following settings will change is displayed.
Click the [OK] button after checking the settings to change the settings to the displayed values.
–
[Image] tab on the “Image” page
[JPEG(1)]
[Image capture size]: VGA/640x360
[JPEG(2)]
[Image capture size]: QVGA/320x180
[Stream(1)]/[Stream(2)]/[Stream(3)]
[Internet mode]: On
[Transmission priority]: Best effort
[Max bit rate (per client)*]: 1024 kbps
[Stream(1)]
[Image capture size]: 1280x960/1280x720
U153x
U253x
U113x
U213x
[Image capture size]: 1920x1080
U154x
U254x
U114x
U214x
[Stream(2)]
[Image capture size]: VGA/640x360
[Stream(3)]
[Image capture size]: QVGA/320x180
–
[Network] tab on the “Network” page
[Common]
[Max RTP packet size]: Limited(1280byte)
[HTTP max segment size(MSS)]: Limited(1280byte)
2.3.2 Configure an event action [Event action]
Click the [Event action] tab in the “Easy Setup” page. (
®
For menu display and how to operate, refer to
Operating Instructions
39
2 Settings
