Restore
[Setup data]
Press the [Browse...] button and select the setup data files to restore.
Click the radio button respective to the desired option to determine whether or not to also restore network
related setting contents.
Click the [Execute] button to start restoring. Do not perform operations until the restoration is complete. (The
camera will be rebooted when the restoration is complete.)
Make sure to set the file name of setup data files used when restoring to “model name.dat”. (The model name
must be written in lower case letters and “WV-” is not needed.)
Default:
Restore all settings except the network settings.
IMPORTANT
•
When 5 minutes or more is required to restore setup data files, there is a possibility that the restore
will fail because or reasons such as transmission disconnections.
In this case, restore setup data files again.
Note
•
Restore operations for setup data are not applied to HTTPS related settings.
[Scene file]
Press the [Browse...] button and select the scene files to restore.
Click the [Execute] button to start restoring. Do not perform operations until the restoration is complete.
Make sure to set the file name of scene file data used when restoring to “model name.txt”. (The model name
must be written in lower case letters and “WV-” is not needed.)
2.11 Display our support website [Support]
Methods for accessing our support website are explained on the “Support” page.
To access our support website from a web browser, click the link for the support page.
To access from a cellular phone/mobile terminal, scan the “Data Matrix” or “QR Code” with your cellular phone/
mobile terminal to display our support website.
Operating Instructions
169
2 Settings
