22
Insert / remove an SD memory card
【2】
Attach the dome cover to the camera.
Note:
Refer to the Operating Instructions on the Panasonic support web site for further information
about the SD memory card settings.
■
Insert an SD memory card
SD memory card
(with label facing outside)
【1】
Remove the dome cover from the camera, insert an SD memory card fully into the SD slot
until a click is heard.
Rear end of SD
memory card
SD slot
Insert the SD memory card with its label facing outside.
Insert the SD memory card with its back end at the same height as the lower part of the
center SD slot until it makes a clicking sound.
Take your fingers off the SD memory card and check that its back end does not protrude
over the upper part of the SD slot.
After the SD memory card has been inserted, press the SD ON/OFF button, and make sure
the SD MOUNT indicator is continually lit.
If you do not press the SD ON/OFF button after inserting the SD memory card, the SD
MOUNT indicator is automatically lit approximately 5 minutes later.
IMPORTANT:
Dome cover is fixed to the camera body by the installed auxiliary wire, so please do not
remove it.
The dome cover is not fixed temporarily. Take care not to hit the dome cover against
periphery.
IMPORTANT:
Fasten the dome cover fixing screws along the diagonal direction.
(Recommended tightening torque: 1.37 N·m {1.01 lbf·ft})
SD ON/OFF button
SD MOUNT indicator