10
Channel setting
Set the infrared transmitting channel of the microphone. Set the channels to match the receiv-
ing channels of the infrared receiver, infrared receiver/amplifier, and infrared wireless powered
speaker used. For details refer to the operating instructions of the receiver.
Note that the channel setup of the microphone differs depending on the infrared receiver,
infrared receiver/amplifier, and infrared wireless powered speaker used.
• For WX-LR100/A, WX-LA20, WX-LA50, WX-LP100
CH1: 2.30 MHz
CH2: 2.80 MHz
• For WX-LR100, WX-LR100/B
CH3: 3.20 MHz
CH4: 3.80 MHz
Important:
• Channels can be set up with the power of the microphone turned on, but to prevent noise it
is recommended to turn down the volume of the powered amplifier, mixer, etc.
CH
4
3
21
Battery cover
2
1
CH
4
3
2 1
Channel select switch
A
1
Remove the battery cover of the
microphone.
Pull the battery cover downward while
pressing the
A
portion with both right
and left thumbs to remove the cover.
2
Set the transmitting channel.
To set the transmitting channel, use the
small channel setting screwdriver
(accessory) to turn the channel select
switch until it clicks in place.
The positions of the channel select
switch correspond to the following chan-
nels.
Position
Channel
1
CH1 (2.30 MHz)
2
CH2 (2.80 MHz)
3
CH3 (3.20 MHz)
4
CH4 (3.80 MHz)
• When set to a position other than 1 to 4, the battery indicator will blink.
• The default is [1].
3TR006021BZA̲WX-LT150 09.5.22 04:08 PM ページ10