Mapping
20
Changing and correcting input areas
The setting values of input areas can be changed.
Input area setting change procedure
Right-click the area for which to change the settings in the screen to display the [Settings] menu.
Select the item you wish to change from the [Settings] menu.
X
[Antenna location]
The antenna installation method can be changed. The antenna installation methods use the recommended location
for antennas.
[Ceiling location]:
Sets the area location setting to ceiling location.
[Wall placement]:
Sets the area location setting to wall placement.
Default setting:
[Ceiling location]
X
[Mic usage side]
Set whether the location to use microphones is all of the area (room) or part of the area. Normally, set this to [All].
[All]:
Uses microphones in all of the area.
[Upper side]: Uses microphones in the upper side of the area.
[Lower side]: Uses microphones in the lower side of the area.
[Right side]:
Uses microphones in right side of the area.
[Left side]:
Uses microphones in the left side of the area.
Default setting: [All]
For example, in the case of a classroom, when microphones will be used not in all of the classroom but in the vicinity of
a podium, select the location of the podium (set whether the podium is located in the upper side, lower side, right side,
or left side of the area).
When other than [All] is set, this software checks the wireless reach of the antennas only for the part set as the
microphone usage location. This allows you to, for example, consider cutting costs by reducing the number of antennas,
etc.
