12
6
3
4
→
·
·
5
7
·
■
●
●
●
●
●
■
■
1
2
1
2
Filling the water tank up and putting salt tablets
into the automatic salt tablet adding assembly
Installing the water tank back
and closing the side panel
Putting salt tablets into the automatic
salt tablet adding assembly
Filling the water tank up
(When the product operates in the “Turbo” mode in an
environment where the room temperature is 20 °C and the relative
humidity is 30%.)
A full tank of water supports continuous operation of
approximately 6 hours. The continuous operation time
may be longer in the “Air volume” mode.
Do not overfill the assembly with salt tablets.
Make sure all of the following
indicators are off.
Be sure to tighten the cover of the automatic salt tablet
adding assembly until the two
△
marks are aligned.
Tighten the cover of the automatic salt tablet adding
assembly and install the assembly into the main unit.
Be sure to use the supplied salt tablets or the
replacement salt tablets specified in "OPTIONAL
ACCESSORIES" (Page 26).
Tightening
Refill the automatic salt tablet adding assembly with salt
tablets (about once every 6 months).
For how to remove the automatic salt tablet adding assembly,
see page 8.
Remove the automatic salt tablet adding assembly from the
main unit, open the cover and put 60~70 salt tablets into the
assembly.
Put the tank back to the product.
Put the tank back to
the product and close
the side panel.
Close the side panel.
Connect the power
plug.
A salt tablet drops
automatically into
the tray.
Make sure to use the tap water.
(Because chlorination has been performed generally for tap water
and hence the miscellaneous bacterium is difficult to breed.)
Warm water above 40
℃
, or water mixed with detergents.
(Otherwise, the tank deformation may be caused.)
Do not use the following water.
Water mixed with chemicals, air fresheners and essential oils.
(Otherwise, the tank may be damaged and the furniture,
appliances, etc. may be wet.
→
Page 5)
Water from a water purifier, alkaline ion water, mineral water
(Otherwise, mildew and miscellaneous bacterium may multiply
fast.)
Well water
(Otherwise, mildew and miscellaneous bacterium breeding may
be caused, discoloration may occur, and the replacement cycle
of the electrode unit may be shortened.)
SETUP
