16
■
●
1
●
2
●
●
●
·
1
●
2
※
·
■
1
2
1
2
CAUTION
Remove the tank from the product
and fill it up with water.
Install the tank back to the product.
When it is time to empty the tray, the drain
indicator lights on.
For the time when the drain indicator lights on,
see page 9.
For how to remove the water tank, see “SETUP”
on page 11.
Drain the tray regularly (about once a
week).
Meanwhile, the digital display scrolls automatically
as a reminder. If the product is in operation, the
operation is stopped.
Notice
Make sure that no water spills
out when carrying the tank or
tray. If any water spills out,
wipe it off immediately.
(If water spills out on the floor, etc.,
discoloration or deterioration may
be caused due to the bleaching
effect of hypochlorous acid.)
Disconnect power supply before water
supply/drainage.
Water supply method
Drainage method
WATER SUPPLY/DRAINAGE METHOD
When the tank need to add water, the product
will sound “BIBI” 5 times and stop operating.
(The water refill indicator lights on.)
Water-level window
Used to check the
remaining amount of
water in the water
supply tank.
For how to remove the tank and fill it up,
see “SETUP” on page 11~12.
For how to reinstall the tank, see “SETUP” on
page 12.
When needed, salt tablets are automatically
added.
The automatic salt adding cycle is ”about 1
tablet per 3 days”. Do not add salt tablets every
time when you add water because the salt
concentration will be increased.
Slider latch (Sliding
while pinching.)
Remove the tray.
Slide up the slider latch to the top.
You cannot take the tray out without lifting
the slider latch (electrode unit). Therefore,
be sure to check that the electrode unit is
lifted before taking the tray out.
Remove the tray from the product.
Remove the tank from
the product.
