PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
CX230 OPERATION
MONITORING AN INDIVIDUAL CHANNEL
Select a channel to be monitored by pressing the pushbutton for the appropriate channel once.
An LED indicator will illuminate above the selected input button. Adjust the volume control for a
comfortable listening level. The volume is indicated by the 2-digit display to the left of the control.
Biamp installations only:
It is possible to monitor each of the front channel high and low frequency outputs separately.
Press the left, centre or right pushbutton once to monitor a mix of the high and low frequency
outputs for each channel.
Press the same button a second time to monitor the high frequency output only. Press the same
button a third time to monitor just the low frequency output.
Repeatedly pressing the same button will cycle through the above three options.
MONITORING A MIX
When the MIX button is pressed, the monitor output will be a blend of the front three channels
(left, centre and right).
The surround channel is not included in the mix. This is because the delay that is normally
introduced in the cinema processor for the surround channel may cause confusing echo effects.
The surround and sub bass channels must be monitored individually.
MONITORING THE PROCESSOR OUTPUTS OR THE AMPLIFIER OUTPUTS
Press the SOURCE pushbutton to select either the outputs from the sound processor or the
outputs from the amplifiers.
Repeatedly pressing the SOURCE button will toggle back and forth between the processor and
the amplifier outputs.
MUTING THE MONITOR OUTPUTS
Press the MUTE button to silence the monitor without changing the volume setting. Press the
MUTE button a second time to restore the monitor output to normal.
(Turning the volume down to zero can also mute the monitor, but in this case the volume must be
turned up again to restore the previous listening level).
