PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
PANASTEREO CX230 CINEMA MONITOR
CX230 INSTALLATION
CONNECTING THE SOUND PROCESSOR OUTPUTS.
NOTE: For non-biamped installations, the left channel should be connected to the LL input, the
centre channel to the CL input and right channel to the RL input.
1.
SOUND PROCESSOR WITH UNBALANCED OUTPUTS (DOLBY, SMART, ULTRA STEREO)
Use two-core shielded audio cable to connect the outputs from the sound processor to the monitor
“from processor” inputs.
Connect the “+” terminal from each sound processor output to the “+” terminal of each
corresponding monitor “From Processor” input.
Connect the ground terminal of each processor output to the “-“ terminal of each corresponding
monitor “From Processor” input.
Connect the cable shield to the “E” terminal of each monitor “from processor” input only. Do not
connect the shields at the sound processor.
2.
SOUND PROCESSOR WITH BALANCED OUTPUTS (PANASTEREO)
Use two-core shielded audio cable to connect the outputs from the sound processor to the monitor
“From Processor” inputs.
Connect the “+” terminal from each sound processor output to the “+” terminal of each
corresponding monitor “From Processor” input.
Connect the “-“ terminal of each processor output to the “-“ terminal of each corresponding
monitor “from processor” input.
Connect the cable shield to the “E” terminal of each monitor “from processor” input only. Do not
connect the shields at the sound processor.
CONNECTING THE AMPLIFIER OUTPUTS.
NOTE: For non-biamped installations, the left channel should be connected to the LL input , the
centre channel to the CL input and right channel to the RL input.
Use light gauge unshielded cable for this purpose.
Connect the “+” (Red) terminal of each amplifier output to the “+” terminal of each corresponding
monitor “From Amplifier” input.
Connect the “-“ (Black) terminal of each amplifier to the “-“ terminal of each corresponding monitor
“From Amplifier” input.
NOTE: DO NOT USE A SINGLE GROUND CONNECTION BETWEEN THE AMPLIFIERS AND THE
MONITOR OR CONNECT THE “-“ (BLACK) TERMINALS OF THE AMPLIFIERS TOGETHER. SUCH
CONNECTIONS MAY CAUSE CROSSTALK, UNPREDICTABLE AMPLIFIER BEHAVIOUR OR DAMAGE
TO WIRING.
