LFO Block
The FI has a dedicated Low Frequency Oscillator (LFO) for modulating the cutoff frequency
of the VCF and the pitch of the VCOs. This can be used to create pitch vibrato and filter
“wobbles”.
Moving from left to right, the sliders of the LFO Block are as follows:
●
LFO FRQ (0.25Hz...28.02Hz):
Sets the frequency of the LFO.
●
LFO DELAY (0…127):
Each time a new note is played an envelope is started that fades in the LFO
amplitude with a variable delay. If set to zero then the set LFO amplitude is reached
immediately.
●
LFO VCF / VCO (0…127):
Sets the LFO depth individually for both destinations.
If desired, the modulation depths of both LFO VCF and VCO can be controlled
together by MIDI CC1. The depth set in the program by the two sliders will be
reached if CC1 is at maximum (127). (See the
section for
more details.)
Note 1:
The LFO can be freely assigned to many other parameters when used as a control
source with a Flexi Controller. (See the section on
for a detailed
explanation.)
Note 2:
The global LFO
cannot
be synced to an incoming MIDI clock signal.
48
