USB Multilink ACP - Technical Summary
PEmicro website: http://www.pemicro.com/products/product_processor.cfm?category=9
9
Third-Party IDEs & Other Compatible Software
The USB Multilink ACP is supported by recent versions of NXP’s MCUXpresso, CodeWarrior, Kinetis Design Studio, S32
Design Studio, STM32CubeIDE, and DAVE IDE, as well as third-party toolchains such as those from IAR, Keil, Silicon Labs.
Cosmic, and Mentor Graphics. A list of third party ARM IDEs can be found at:
http://www.pemicro.com/arm/3rd-party/index.cfm
Multilinks also work with PEmicro software, including our no-cost, fully-featured GDB Server Plug-in for Eclipse-based ARM
IDEs.
It is recommended that you check with the vendor regarding support for your specific part. Information on compatible PEmicro
software can be found in the “Products” section of PEmicro’s website: pemicro.com.
10
Transition To Production Programming
The USB Multilink ACP is intended for development and is not designed
to accommodate the demands of production programming. However,
PEmicro’s Cyclone LC and Cyclone FX programmers are specifically
engineered to withstand the rigors of a production environment and will
provide a seamless transition from the Multilink. Both include PEmicro’s
Cyclone Control Suite for Cyclone control and automation. In addition,
Cyclone FX programmers offer an extended feature set including larger
internal storage, expandable storage, faster communications, enhanced
security, advanced Cyclone Control Suite features, and extension
ports.More information is available online at pemicro.com/cyclone.
Cyclone Programmer
