22
Ready to Watch TV?
1. Power on your KTC and other AV devices if necessary.
2. If the TV does not display promptly, press
SOURCE
to verify that
TV
is selected as your source (or a
different source according to the connection method you used in the
Connection Suggestions
pages beginning on page 18.)
‘No Database’ Message
If the message
“No Database’
appears when you
are
connected to digital cable,
and
TV
is selected as
your source, the KTC may not be receiving a strong enough signal for the current channel to be
displayed. Perform the
Initial Tuner Setup
per the following instructions.
Initial Tuner Setup
The first time you power on the KTC after connecting a digital Coaxial RF cable, perform the following
initial setup and then your TV will be ready for viewing.
Note
: Use the remote control to perform the initial tuner setup functions.
1. Press
MENU
to display the OSD menu.
2. Press
VOL+
or
VOL-
to highlight the
TV
option.
3. Press
CH-
to highlight
TUNER MODE
and press
VOL+
to select
Cable
or
Air
(antennae).
4. Press
CH-
to highlight
AUTO SCAN.
If you have
Cable
selected, set
Cable System
to
AUTO
.
5. Press
VOL+
to highlight
START TO SCAN
and then
VOL+
again to start the scan.