11
6. Press to turn scanner on.
It is recommended that you read the next section, “Considerations for all Scanning”, before
attempting your first scan.
The battery is not required to operate the scanner when it is engaged in the feeder dock.
Turning
the
Scanner
Off
To turn the scanner off, press and hold
for three seconds.
Now you can safely remove the SD card from the scanner.
The scanner has a power-saving feature which automatically turns the scanner off
when it’s left idle for a specified number of seconds
(if not connected to a computer)
. To
set the Power Saving time, see the “Set the Power Saving Time” section on page 18.
Cons id e rat ion s
f or
al l
Sc an nin g
Always insert a SD card before scanning.
Do not remove the SD card or disconnect the power supply while the indicators are blinking.
Keep the original flat and level when feeding to prevent possible jamming.
Keep originals free from finger prints, oil, dirt, and dust for optimum scanned image quality.
The feeder dock’s sensor is triggered when you begin to insert an original aligned against the
left edge of the feed slot, and then the original begins to automatically feed, hesitates and then
completes the scan.
To prevent poor cropping effect, align original straight against left edge of the feeder slot, align
the Guide Slide against the right edge of the original, and ensure there is adequate space
behind the feeder dock for the original to complete the scan feed.
Scanning the same original in different orientations may produce scanned images that look
slightly different in color tones and brightness. This is not a malfunction.
If the SD card is full, the indicator light blinks red and LCD displays “Card Full”. Use another
card or delete some files on it if necessary.
The scanner only accepts SD cards in FAT16 or FAT32 file system. NTFS and other file
systems are not supported.
This scanner supports output images in JPG and PDF formats. (The date & time attributes will
be a pre-assigned fixed value, unless you set the Date & Time option before scanning. See the
Date & Time section on page 21.)
The feeder dock requires 5V 1.0A power adapter to operate and to charge the rechargeable
battery (when the scanner is off).
The battery is not required to operate the scanner when it is engaged in the feeder dock.
The wand scan mode requires you to press
to begin scanning an original, and then press
again to stop the scan.
Only the wand scan mode supports the “anti-mirror” feature.
In wand scan mode, if the “Low Battery” message appears on the LCD screen, your scanned
images may be lower quality and the scanner may malfunction. Recharge the battery as soon
as possible.
