21
20
USER MANUAL
PANDORA DXL 0110L CAR SERVICE-SECURITY SYSTEM
Programming using VALET button
The system allows programming some settings using
VALET
button. To
configure all settings use a computer to program the system.
Enter programming mode by entering «Service PIN-code», Use
VALET
button to enter the desired level number (press the button a number of times,
equal to level number; pauses between presses should not exceed 1 second).
The system will confirm correct input with red
LED
flashes and short sound
signals of the siren/Beeper and proceed to the desired level. If the input was
incorrect, the system will not confirm input and will await a new level input
after a series of green and red flashes
Level 1
Registration of radio tags (BT760)
Level 2
Changing the factory preset service PIN-code
Level 3
Recording idle speed
Level 4
Resetting to factory settings
Level 5
Registration of Bluetooth engine compartment
module (RHM-03 BT)
Level 6, 7
Registration of Bluetooth radio relays №1, №2
(BTR-101)
Level 8
Reserved
Level 9
Reserved
Level 10
Configuring system settings via the wireless
interface
Level 11
Programming and configuring «immobilizer PIN-
code»
Level 12
Reserved
Level 13, 14
Reserved
Level 15
Emergency disabling of immobilizer radio tag
Level 16
Update Bluetooth modem firmware
Level 17
Reserved
Level 18
Register and unregister mobile device
Level 19, 20
Update radio relays №1, №2 firmware
Level 21
Update Bluetooth engine compartment module
firmware (RHM-03 BT)
Level 1 – Registration of radio tags into the system’s memory
Prepare to register all radio tags (you can register up to 3 tags), install
batteries in the radio tags.
Enter programming menu and then press
VALET
button once.
LED
indicator will light green and the system will enter the tag registration mode.
Tags are registered (paired) one by one, in any order and without time limit. All
previously registered radio tags will be removed when you overwrite new tags
or overwrite old tags.
Registration of radio tags:
Press control button on the tag and hold it for 6 seconds (6 flashes of tag
status indicator), release the button after the sixth flash. If the recording was
successful, the siren/Beeper will emit 1 beep, after that you can move to
recording the next tag.
Saving changes:
To finish the registration of the radio tags into the system,
VALET
button
should be pressed once again, the series of red and green flashes of status
LED
indicator with the series of sound signals of the Beeper will confirm the saving.
Level 2 – Changing the factory preset service PIN-code
Prepare new value of the «Service PIN-code», it should consist of 4 digits
(from 1 to 9). Write down or remember the new PIN-code.
Enter programming menu and then press
VALET
button twice. The system
will enter «Changing Service PIN-code» mode and the status
LED
indicator will
turn off.
