51
50
USER MANUAL
PANDORA DXL 1090L SERVICE-SECURITY SYSTEM
Entering PIN-code:
• Enter the first digit of the code using
VALET
button. Press the button a number of
times, equals to the first digit. Pauses between presses should not exceed 1 second.
Each pressing will be confirmed with an orange
LED
indicator flash. A Pause for
more than 1 second and a red
LED
indicator flash confirm the input of the first
digit. Then you can enter the next digit.
• Enter the second digit of the code using
VALET
button. Press the button a
number of times, equals to the second digit. Pauses between presses should not
exceed 1 second. Each pressing will be confirmed with an orange
LED
indicator
flash. A Pause for more than 1 second and a red
LED
indicator flash confirm the
input of the second digit. Then you can enter the next digit.
• Enter the third digit of the code using
VALET
button. Press the button a number
of times, equals to the third digit. Pauses between presses should not exceed 1
second. Each pressing will be confirmed with an orange
LED
indicator flash. A
Pause for more than 1 second and a red
LED
indicator flash confirm the input of
the third digit. Then you can enter the next digit.
• Enter the fourth digit of the code using
VALET
button. Press the button a number
of times, equals to the fourth digit. Pauses between presses should not exceed
1 second. Each pressing will be confirmed with an orange
LED
indicator flash.
The system will confirm correct PIN-code with the series of red and green flashes
and the system will enter programming mode. If the input was incorrect, it will be
indicated with a red
LED
indicator flash and the system will stay in a previous state.
New input can be attempted after 5 seconds.
Exit programming mode:
To exit programming mode turn on the ignition or turn off power of the base unit.
The system will reboot programmatically (all changes will be saved) after exiting
programming mode using ignition. All ways to exit the programming menu are
accompanied by sound signals of the siren and light signals of the
LED
indicator.
Light signals indicate the number of recorded devices: first green flashes indicate the
number of recorded radio tags, red flash indicates registered mobile device.
P R O G R A M M I N G T H E S Y S T E M
P R O G R A M M I N G T H E S Y S T E M
• the first orange flashes indicate the number of recorded remote controls,
• the next green flashes indicate the number of recorded radio tags,
• the last red flash indicates registered mobile device.
Status indicator lights during PIN-code entering:
Short orange flash
Confirmation of VALET button pressing
Short red flash
Confirmation of entering a PIN-code digit
Red and green flashes
PIN-code is correct
Long red flash
PIN-code is incorrect
PREPARING TO PROGRAM THE SYSTEM USING A COMPUTER
The system allows programming all settings and updating software of the base unit
via micro-USB cable. If the base unit has not been installed in the vehicle yet, it will be
powered via micro-USB cable while programming. To program using a computer, you
need a standard USB cable, a computer with Windows XP/Vista/7/8/10 and
Pandora
AlarmStudio
application (you can download it from
pandorainfo.com
).
It is required to create an account in AlarmStudio to use Pandora CLONE for remote
engine start (you can register without a connection to a system). Pandora CLONE
procedure requires Internet connection.
In preparation to the programming these stages should be followed:
• connect the system and PC via USB cable;
• start Pandora AlarmStudio;
• enter the programming settings mode by entering the «service PIN-code».
