53
52
USER MANUAL
PANDORA DXL 1090L SERVICE-SECURITY SYSTEM
UPDATING FIRMWARE
It is recommended to update firmware of the base unit before installing and programming
the system (actual version of the firmware you can download from
pandorainfo.com
).
You can update firmware using AlarmStudio application after entering programming
mode or using quick boot algorithm (PIN-code is not required).
Quick boot mode: open AlarmStudio; de-energize and disconnect the system;
press and hold
VALET
button located on the base unit; release the button
immediately after connecting the system and a computer via USB cable; the system
will enter boot mode.
If the boot mode has been interrupted for some reason and the status indicator lights
red, you need to load firmware using quick boot mode (without entering the PIN-code).
PROGRAMMING USING VALET BUTTON
The system allows programming some settings using
VALET
button. To configure all
settings use a computer to program the system.
Enter programming mode by entering the «Service PIN-code», Use
VALET
button
to enter the desired level number (press the button a number of times, equals to the
level number; pauses between presses should not exceed 1 second). The system will
confirm correct input with red
LED
flashes and short sound signals of a siren and
proceed to the desired level. If the input was incorrect, the system will not confirm
input and will await a new level input after a series of green and red flashes
P R O G R A M M I N G T H E S Y S T E M
Level 1
Recording remotes and radio tags into the system’s memory
Level 2
Changing the factory preset of the «Service PIN-code»
Level 3
Recording the idle speed to the system memory
Level 4
Resetting to factory settings
Level 5
Recording Bluetooth engine compartment module
P R O G R A M M I N G T H E S Y S T E M
Level 6, 7
Recording Bluetooth radio relays №1, №2
Level 8
Recording Bluetooth GPS/GLONASS receiver
Level 9
Reserved
Level 10
Configuring system settings via the wireless interface
Level 11
Programming and configuring «Immobilizer code»
Level 12
Calibrating of fuel level
Level 13, 14
Reserved
Level 15
Emergency disabling of immobilizer radio tag
Level 16
Updating Bluetooth modem firmware
Level 17
Programming bypass original immobilizer
Level 18
Registering and unregistering mobile device
Level 19, 20
Updating radio relays №1, №2 firmware
Level 21
Updating RHM-03 BT firmware
Level 22
Updating NAV-035 BT firmware
Level 23, 24
Recording door sensors №1, №2 (DMS-100 BT)
Level 25, 26
Updating DMS-100BT firmware
Level 1 – Recording remotes and radio tags into the system’s memory
Prepare to record all remote controls(you can record up to 4 remote controls) and
radio tags (you can record up to 3 tags), install batteries in the radio tags.
Enter programming menu and then press
VALET
button once.
LED
indicator will
light green and the system will enter the remote controls and tags recording mode.
Remote controls and radio tags are recorded (paired) one by one, in any order and
without time limit. All previously recorded remote controls will be removed when you