AT-HDVS-CAM-HDMI
22
Device Operation
Multiple Camera Control
There may be environments where more than one camera is being used. The included IR remote control unit
provides a way to select and control up to four separate cameras.
Before the IR remote control unit can be used to control different camera, each camera must be assigned an address
ID. It is possible to assign multiple cameras with the same ID. However, if all cameras are within close vicinity, IR
remote control commands will be distributed to all cameras. This may not always be desirable.
Assigning / Changing the Camera Address ID
Selecting a Camera for Control
1. Point the IR remote control at the front of the AT-HDVS-CAM-HDMI.
2. Assign the camera an ID by sequentially pressing the following series of buttons listed in the table below.
1. Point the IR remote control at the front of the desired AT-
HDVS-CAM-HDMI.
2. Press the button of the camera ID, which is being controlled,
within the
CAMERA SELECT
button group on the IR remote
control.
3. Press the buttons on the IR remote control for the desired
operation of the camera.
Camera Address ID
Keystrokes
1
[*] + [#] + [F1]
2
[*] + [#] + [F2]
3
[*] + [#] + [F3]
4
[*] + [#] + [F4]
3. Follow the above steps for each camera. Each camera can
have a distinct ID. For cameras that have been assigned
unique ID addresses, it may be helpful to place a label on
each camera for future reference.
HOME
SET
F1
F2
F3
F4
1
AUTO
MANUAL
FOCUS
ZOOM
2
3
1
2
3
4
5
6
7
8
9
*
8
#
+
_
_
+
4
CAMERA SELECT
SET
PRESET
CLEAR
PRESET
BLC
ON/OFF
MENU
HOME
SET
F1
F2
F3
F4
1
AUTO
MANUAL
FOCUS
ZOOM
2
3
1
2
3
4
5
6
7
8
9
*
8
#
+
_
_
+
4
CAMERA SELECT
SET
PRESET
CLEAR
PRESET
BLC
ON/OFF
MENU
Function buttons
Camera Select
# button
* button
