AT-OMNI-111-WP
36
Advanced Operation
9. Click the
Enable Encoder Group
toggle switch to enable encoder grouping. When enabled, this toggle switch
will be green.
10. Click the
Trigger
drop-down list and select the desired trigger mode.
11. Click the
SAVE
button, at the bottom of the
Stream
window group to commit all changes.
Mode
Description
manual
Use this setting to manually enable the input. When set to
manual
, click the
Activate
button to perform the input switching.
input
connected
Use this setting to allow the encoder group to use automatic input detection. Once a
new source is connected, that source becomes the active source.
NOTE:
Setting
Trigger
to
input connected
should not be used when
Slate Mode
is set to
Auto
.
Doing so will cause the slate to be displayed when switching inputs. If encoder auto-switching is
being used, set the
Slate Mode
to
Auto
, on the decoder. Refer to
Slate / Logo Insertion (page 40)
for more information.
Enable Encoder Group