AT-OMNI-111-WP
53
The AMS Interface
Advanced Settings
DSCP
Select the Differentiated Services Code Point (DSCP) type from the
DSCP
drop-down list. This value will be used to
determine the Quality of Service (QoS) on a network. The available values are:
Best Effort
,
Low
,
Normal
,
High
, and
Highest
. The
Best Effort
setting will provide normal priority for data packets, while a setting of
Highest
will prioritize
data packets as critical. However, it should be noted that a higher priority setting may also result in high data packet
loss, depending upon network traffic.
FEC Enable
Click this toggle switch to enable (green) or disable Forward Error Correction (FEC). This feature can be used when
transporting streams over a network that is suspected to be unreliable, due to noise or other factors. By default, this
feature is enabled. Refer to
for more information.
FEC rows
Specify the number of FEC rows in this field. Refer to
for more information.
FEC Columns
Specify the number of FEC columns in this field. Refer to
for more information.
Group Name
The name of the encoder group.
Enable Encoder Groups
Click this toggle switch to enable (green) or disable encoder groups for the stream.
Active
Indicates if the encoder group is active. If active, this indicator will be green.
Trigger
Click this drop-down list to select the trigger type:
manual
or
input connected
.
ACTIVATE
Click this button to activate the encoder group.
ADD
Click this button to add the IP address of an encoder to the encoder group.
Click the
SHOW ADVANCED
button to view the following options.
DSCP
,
FEC Enable
,
FEC Rows
, and
FEC
Columns
apply to both
Video
and
Audio
sections.
