AT-OME-MS42
25
Device Operation
Scaler Pass-Through
Click this toggle switch to enable or disable the scaler pass-through feature. When set to the
ON
position,
4K content will be down-scaled to 1080p. When set to the
OFF
position, the output resolution / timing will be the
same as the input source. The default setting is
ON
.
1.
Login to the web server. Refer to
Introduction to the Web Server (page 52)
.
2. Click
A/V Settings
in the menu bar.
3. Click the
Scaler
toggle switch.
4.
The following message box
will be displayed. Click
OK
to
dismiss the message box.
5. The
Scaler
toggle switch will be
set to the
ON
state.
6.
Click the toggle switch again, to
return the
Scaler
toggle to the
ON
(default) position.
IMPORTANT:
The scaler will only downscale the image resolution and does not support frame rate
scaling/conversion such as 60 Hz to 30 Hz. The frame rate of the source must be supported by the
display device.
