AT-OME-MS42
18
Device Operation
Switching Modes
The AT-OME-MS42 features three switching modes: Mirrored, Matrix Mode, and Matrix Mode with static route.
Each of these modes will be covered in the following section. Switching modes can be configured using the built-in
web server.
This is the default mode. Once video is detected on any of the input ports, the output signal will be displayed on
both
the
HDMI OUT
and
HDBaseT OUT
ports. The active input will be identified on the front panel HDMI LED input
indicators. An active input will be displayed as a solid green LED.
can also be enabled,
if desired, to allow the AT-OME-MS42 to automatically switch between inputs, if a new source is connected or an
existing source is disconnected.
1.
Login to the web server. Refer to
Introduction to the Web Server (page 52)
for more information.
2. Click
A/V Settings
in the menu bar.
3. Click the
Switching Mode
drop-down list and select
Mirrored
.
Mirrored Mode
4.
Mirrored configuration is complete.
