AT-UHD-CAT-XX
4
Commands
Command
Description
Sets the function of the
POWER
button on the front panel
Enables or disables blinking of the
POWER
LED indicator on the front panel
Enables or disables broadcast mode
Sets the baud rate, data bits, parity bit, and stop bits for the serial port
Saves the downstream EDID to the specified internal memory location on the unit
Assigns the specified EDID to the
HDMI IN
port
Sets the EDID mode
Set the HDCP reporting mode of the specified
HDMI
input port
Displays the list of available commands
Displays the status of the input as either a 0 or 1
Adds a user for Telnet and webGUI access
Displays the current network settings for the unit
Deletes the specified user
Enables or disables DHCP mode on the unit
Enables or disables login credentials when starting a Telnet session
Sets the Telnet listening port for the unit
Closes the current Telnet session
Sets the static IP address, subnet mask, and gateway for the unit
Sets the time interval of inactivity before the Telnet session is terminated
Locks the buttons on the front panel
Resets the unit to factory-default settings
Displays the status of the outputs as either a 0 or 1
Execute this command to power-off the unit
Execute this command to power-on the unit
Displays the power state of the unit
Displays the status of the unit
Triggers the specified command
Displays the model of the unit
Unlocks the buttons on the front panel
Displays the current firmware version of the unit