Installation Guide
AT-VTP-800
3
Stand
1
Place the stand on the table/desk
a
If the rubber no slip guard is not secure enough, use four wall screws and thread them
though the four holes on the bottom of the unit and into the desk/table.
2
Thread the Ethernet cable through the bottom rounded hole on the back of the stand and
back out the rectangular hole on the front of the stand.
3
Plug the Ethernet cable into the back of the touch panel.
4
Place the touch panel on the stand, pushing the excess cable back through the stand at the
same time as resting the back panel of the touch panel in the rectangular front hole of the
stand.
5
Secure the touch panel to the stand using the four stand screws (included in the stand box).
a
Thread the screws through the 4 pre-drilled holes in the front of the stand into the four
screw holes on the back of the touch panel.
NOTE:
Tight the screws by hand. To avoid damage to the touch panel, do not
overtighten.
