AT-WAVE-101
26
webGUI
IP Commands
IP Address and Port
- Type in the IP address and port
of the display for commands to be sent to.
Time Display Control
Enable this section to have the Power On/Off
command automatically sent to the display at a
certain time of day on different days of the week.
Start/End Time
- Select the field for a clock pop up to
appear. This will allow the start or stop time to be set
easily.
Days
- Select the sliders next to the days of the week
to have the automatic on/off command to be sent.
The slider will be orange when enabled and grey when
disabled.
NOTE:
If content is actively being displayed
during the off time, the WAVE-101 will delay the
power off sequence until all content has been
disconnected from the system.
