3
Installation Guide
AT-OMNI-311
The AT-OMNI-311 includes two mounting brackets, which can be used to attach the units to any
flat surface.
1. Remove the two enclosure screws, on both sides of the unit, using a small Phillips-head
screwdriver.
2. Position one of the mounting brackets, as shown below, aligning
the holes on the side of the enclosure with one set of holes on
the mounting bracket.
3. Attach the mounting brackets using the
enclosure screws from Step 1.
4. Mount the unit using the oval-
shaped holes, on each mounting
bracket. If using a drywall
surface, a #6 drywall screw is
recommended.
Mounting Instructions
PWR
LINK
SIGNAL
HOST
O
MNI
S
TREAM
TM
NOTE:
The unit can also be mounted under a table or other flat surface.
PWR
LINK
SIGNAL
HOST
O
MNI
S
TREAM
TM
PWR
LINK
SIGNAL
HOST
O
MNI
S
TREAM
TM
