AT-OMNI-324
21
The AT-OMNI-324 includes two mounting brackets, which can be used to attach the units to any flat surface.
1.
Remove the two enclosure screws, on both sides of the unit, using a small Phillips-head screwdriver.
2.
Position one of the mounting brackets, as shown below, aligning the holes on the side of the enclosure with one
set of holes on the mounting bracket.
3. Attach the mounting brackets using the enclosure screws from Step 1.
4.
Mount the unit using the oval-shaped holes, on each mounting bracket. If using a drywall surface, a #6 drywall
screw is recommended.
HOST
LINK
PWR
O
MNI
S
TREAM
TM
SIGNAL
USB
USB
USB
USB
NOTE:
The unit can also be mounted under a
table or other flat surface.
HOST
LINK
PWR
O
MNI
S
TREAM
TM
SIGNAL
USB
USB
USB
USB
HOST
LINK
PWR
O
MNI
S
TREAM
TM
SIGNAL
USB
USB
USB
USB
Appendix
Mounting Instructions