AT-OMNI-324
20
Basic Operation
DHCP Reset
Use the following instructions to reset the device to DHCP mode. Resetting to DHCP mode will not remove any
pairings and if the device is already paired, it will remain paired.
1. Disconnect power from the unit.
2. Reconnect power to the unit, and within 5 seconds, press and hold the
PAIRING
button.
3. Continue holding the
PAIRING
button for 15 seconds, then release.
4.
Power-cycle the unit once again, by disconnecting and reconnecting the power. Let the unit boot up normally.
5.
The unit is now in DHCP mode and will automatically be assigned an IP address by the DHCP server, if one is
present on the network.
HOST
LINK
PWR
O
MNI
S
TREAM
TM
SIGNAL
USB
USB
USB
USB
LAN
PAIRING
UTILITY
AT-OMNI-324
DC 24V
PAIRING button