Basic Rack PDU User Manual
-
6
-
Part Numbering Format
This section describes the part numbering format used to identify equipment in the PDU
series. PDU devices are numbered using one of the following formats:
l
H1M-ABCDEFGHJKLM
l
V1M-ABCDEFGHJKLM
The H1M prefix indicates that the model is intended for horizontal mounting.
The V1M prefix indicates that the model is intended for vertical mounting.
The remaining letters in the series represent values as defined in the table below.
Letter
What It Represents
A
Any numeral, 1-8, indicating the phase wiring for the output circuit break-
ers and receptacles
B
Any letter, A-F, indicating input cord configuration
CD*
Any numeral, 1-5, and any letter, A-Z, indicating input plug type and
rated voltage
E
Any numeral, 1-7, indicating the number of output circuit breakers
F
Any letter, A-Z, indicating the type of overload protection provided for
the outlets
GH
Any two numerals, 01-45, indicating the number of output receptacles
provided
JK
The letter ‘A’ or ‘B’ followed by any letter, A-Z, indicating the type and
quantity of output receptacles provided
L
Any numeral, 0-9, or any letter, A-Z, indicating the length of the power
supply cord
M
Any numeral, 0-9, indicating the color of the enclosure
* Voltage and amperage ratings:
l
120V, single-phase, 10A, 12A, 15A, 16A, 20A, 24A or 30A
l
208V, single-phase, 10A, 12A, 13A, 15A, 16A, 20A, 24A, 30A, 48A or 60A
l
230V, single-phase, 16A, 32A, or 48A
l
208V, three-phase (delta), 16A, 20A, 24A, 30A, 40A, 48A, 50A or 60A, 3W + PE
l
208V, three-phase (wye), 16A, 20A, 24A, 30A, 48A or 60A, 3W + N + PE
l
400V, three-phase (wye), 16A, 20A, 24A, 30A, 32A, 48A or 60A, 3W + N + PE
