© Panduit Corp. 2017
OPERATION MANUAL
CT-902HP
FAMILY
Page: 2 of 6
INTRODUCTION
The CT-902HP family of hydraulic pumps:
CT-902HP
110 V Hydraulic Pump with Hand Pendant Switch
CT-902HPRCH
110 V Hydraulic Pump with Remote Control Handle
CT-902HPRFS
110 V Hydraulic Pump with Remote Foot Switch
CT-902HP220
220 V Hydraulic Pump with Hand Pendant Switch
CT-902HP220RFS
220 V Hydraulic Pump with Remote Foot Switch
The CT-902HP family of hydraulic pumps are capable of providing 10,000 PSI (700 bar). Panduit recommends
using their CT-902HP family of hydraulic pumps with the CT-900HPH Hydraulic Pump Hose, which can crimp #8
AWG thru 1500 MCM Panduit Copper Compression Connectors; and #6 AWG thru 1000 MCM Panduit Aluminum
Compression Connectors. Refer to the product packaging for wire size and crimp designations.
This manual will guide you step-by-step in operation and maintenance of your Hydraulic Pump.
If you have problems not covered, call:
1-800-777-3300
The information contained in this literature is based on our experience to date and is believed to be reliable. It is intended as a
guide for use by persons having technical skill at their own discretion and risk. We do not guarantee favorable results or
assume any liability in connection with its use. Dimensions contained herein are for reference purposes only. For specific
dimensional requirements consult the factory. This publication is not to be taken as a license to operate under, or a
recommendation to infringe any existing patents. This supersedes and voids all previous literature, etc.
NOTE: In the interest of higher quality and value, Panduit products are continually being improved
and updated. Consequently, pictures may vary from the enclosed product.
1) Work area safety
a)
Keep work area clean and well lit
.
Cluttered or dark areas invite accidents.
b)
Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
Power tools create sparks which may ignite the dust or fumes.
c)
Keep children and bystanders away while operating a power tool.
Distractions can cause you to
lose control.
2) Electrical safety
a)
Always disconnect plug from outlet before performing any service on the pump.
b)
Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
c)
Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of electric shock if your body is earthed or grounded.
d)
Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase
the risk of electric shock.
e)
Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords
increase the risk of electric shock.
f)
When operating a power tool outdoors, use an extension cord suitable for outdoor use.
Use of
a cord suitable for outdoor use reduces the risk of electric shock.
g)
If operating a power tool in a damp location is unavoidable, use a ground fault circuit
interrupter (GFCI)” protected supply.
Use of an GFCI reduces the risk of electric shock.
3) Personal safety
a)
Stay alert, watch what you are doing and use common sense when operating a power tool. Do
not use a power tool while you are tired or under the influence of drugs, alcohol or
medication.
A moment of inattention while operating power tools may result in serious personal
injury.
