DP
O
E™
Power System User Manual
Part Number: PN380C
3
Table 2:
DP
O
E™
Power Components Available from
PANDUIT
PANDUIT
Part Number
Description
DPOEPWRB120Y
Individual power supply - 120 watt power supply –
48 volt output
DPOEPWRCU Unmanaged
power
chassis (supports 3 rectifiers)
DPOEPWRR500
500 watt rectifier for use in power chassis
DPOEPWRR1250
1250 watt rectifier for use in power chassis
DPOEPWRF7.5
7.5 amp fuse (package of 8)
DPOEPWRF5
5 amp fuse (package of 4)
CORD-A
Power cord for Australia
CORD-E
Power cord for Europe
CORD-S15
Power cord for North America
CORD-J15
Power Cord for Japan
CORD-U
Power cord for the U.K.
Heat Dissipation
The following table displays the maximum and typical British Thermal Units per hour (BTU/hr) of heat
dissipated from each rectifier. The maximum is calculated at 90 VAC, and typical is calculated at 230
VAC.
Table 3: Heat Dissipation
Part Number
Typical BTU/hr
Max BTU/hr
DPoEPWRR500 249
410
DPoEPWRR1250 451
833
AC Input Wiring
The
DP
O
E™
Power System chassis uses an individual AC feed architecture (See
Figure 2: Individual AC Feed Wiring
Architecture), which requires one AC feed per rectifier. Up to three,
AC connections are made using the IEC320 receptacles on the rear of the chassis (See
Figure 8: Chassis (Rear View) - AC
Connections).
Connect each feed, using the appropriate power cord as listed in
Table 2: DPoE™
Power Components
Available into the appropriate receptacle on the back of the system. Cord securing brackets are included
to secure the AC plugs to the chassis (See
Figure 9: Securing Cord Bracket to Chassis
).
