15
ES2P
PDU INSTALLATION MANUAL
Section 3 – Connecting the PDU
Connecting the PDU to a Power Source
Always follow local and national codes when installing the PDU. The PDU should be
connected to a dedicated circuit protected by a branch circuit breaker matching the PDU
input plug type.
NOTE:
When connecting the PDU to a Power Source, make sure that you have enough
length in the PDU power cord to reach the PDU power source.
1.
Turn the feed circuit breaker Off.
2.
Make sure that all circuit breakers on the PDU are set to On.
3.
Connect each PDU to an appropriately rated branch circuit.
NOTE:
Refer to the label on the PDU for the input ratings.
4.
Turn the feed circuit breaker On. The LCD screen (on units with display) will
display a status bar when the PDU operating system is loading. When complete, the
Main Menu will display on the LCD screen. Switched and Monitored & switched PDUs
show a light corresponding to each outlet as it is powered up.
