INSTALLATION INSTRUCTIONS FS006
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 6 of 11
Place slack spools over #10-32 studs on sliding
tray. Secure with #10-32 hex nuts and/or adhesive
mounts (be sure to punch hole into adhesive
mounts). Note spool orientation.
Position FAPs between upright flanges as shown.
Once mounted, fully seat NyLatch fasteners to
secure FAPs.
Slack Spools
Field Termination or Pre-Terminated Trunk Installation
Figure 8
Figure 8A
Isometric view showing drawer
fully extended and tilted down
(cables omitted for clarity).
Fully extend drawer to ensure proper amount of
slack is used.
Top view with cover removed.
Please note orientation of spools.
Fiber Adapter Panels (FAPs):
Up to 4 for FEC1U, FCE1UA.
Up to 8 for FCE2U.
