INSTALLATION INSTRUCTIONS FS006
For Technical Support: www.panduit.com/resources/install_maintain.asp
Drawer in home position
Page 9 of 11
Figure 9C
Drawer in extended position
Figure 9B
Fixed
T
AK
-T
Y
Tape
Grommet
Route fiber through grommet as shown.
Use enough cable length to ensure one
complete loop
(approx. 45" [1.15m])
of
individual fibers around FOSM slack
spools.
Route 900µm buffered fiber from the
trunk cable and splice to pigtail per
instructions in FS001,
“
O
PTICOM
Fiber
Optic Splice Module Installation
Instructions.
”
Leave enough jacketed slack so when
the drawer is fully extended the cables
are not put under tension. However, do
not use so much slack that the drawer
cannot be returned to its home position.
(See Figure 9C)
Use
T
AK
-T
Y
Tape to secure fiber cords at
cable entry location and other points as
shown.
Individual
fiber
breakout
point (See
Fiber
Breakout
Detail on
page 7).
Free-floating
T
AK
-T
Y
Tape
Use
T
AK
-T
Y
Tape to
fasten cable to fence.
Sub-unit
tubes
“A”
“B”
Cable length
between point
“A” and point
“B” is approx.
36" [.914m].
