Panduit FMT1J Installation Instructions Download

Page: 2 / 4

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

FS066

Page 2 of 4

DISCARD

Cut the small
circle for 1"
diameter
innerduct

Cut the large
circle for the
1-1/2" diameter
innerduct

Cut the straight
lines when not
using any
innerduct

Determine which grommet(s) will be used to bring the cable
into the enclosure. Follow the diagram for cutting locations.

If you utilize cable entry through a grommet knockout location,
use pliers to grip the knockout and twist to remove.

To remove strain relief knockout, strike the knockout disk with a
screwdriver and remove disk. Install strain relief.

Note: Enclosure comes with the brackets installed in the
recessed position.

Flush enclosure bracket installation on 19" rack

Recessed enclosure bracket installation on 19" rack

Grommet knockout

Strain Relief knockout

Plunger

Part Number

FMT2J16
FMT2J18
FMT2J20
FMT2J24

FMT1J4
FMT1J6
FMT1J8
FMT1J12

FAP*HWBUDSC

2
0
4
0

0
2
0
4

8
0
1
0

0
6
6
8

Summary of Contents for FMT1J

Page 1: ...cable in use Follow TIA EIA 568 A 569 606 and 607 installation guidelines where applicable DANGER UNMATED CONNECTORS MAY EMIT INVISIBLE LASER RADIATION DO NOT LOOK DIRECTLY INTO THE END OF THE CONNEC...

Page 2: ...for cutting locations If you utilize cable entry through a grommet knockout location use pliers to grip the knockout and twist to remove To remove strain relief knockout strike the knockout disk with...

Page 3: ...Page 3 of 4 Enclosure mounts to rack with the M5 screws and flat washers M6 screws or 12 24 screws provided Insert cable through appropriate entry location Strip one meter of jacket from the end of th...

Page 4: ...4 Slide cover forward and secure with M5 screw Affix fiber caution label and fiber laser beam warning label where they are clearly visible Splice cables per manufacturers instructions Gently route ex...