LABELING EXERCISES
60
Exercise 7
Create DIN rail terminal block labels
NOTE:
DIN rail terminal block labeling is based on European standards
and is primarily used in European countries. The unit of
measure for length in DIN Mode is millimeters (mm).
Step 1: Insert a continuous tape cassette, such as T050X000VPC-BK
Step 2: When prompted, select New Blank File. Save previous label if
necessary.
Step 3: Press F5 to begin the DIN Mode function.
Step 4: Enter the Module Size. The Module Size is a length
measurement. The Module Size can be any number between 5 mm and
99 mm.
Step 5: Enter the Module Span. The Module Span is a multiplier. The
Module Span can be any number between 1 and 9. The resulting length
of a DIN module label section is the Module Size multiplied by the Module
Span. For example, a Module Size of 10 mm and Module Span of 2
equal a DIN label section of 20 mm. DIN labeling allows you to print
consecutive label sections on continuous tape of varying lengths.
Step 6: Create label text or tools
Step 7: Press PRINT
Step 8: Repeat steps 4 through 6 until print job is complete
Step 9: Press DEL at steps 4 or 5 to exit DIN Mode and return to the
home screen.
Exercise 8
Create a faceplate or patch panel label
Step 1: Insert a network component label, such as C252X030FJC
Step 2: When prompted, select New Blank File. Save previous label if
necessary.
Step 3:
Enter the number of ports required (ie. 4)
Step 4: Type “A”
Step 5: Press the INSERT key and select
Serial
Step 6: Enter a start value of 01, stop value of 04, and
increment value of 1
Step 7: Press ENTER
Step 8: Press PRINT
Results:
A01 A02 A03 A04
Summary of Contents for LS8-PCKIT
