INSTRUCTIONS CM408F
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 13 of 24
Single Hinge Door Handle Direction Reversal
NOTE:
N
ET
-S
ERV
cabinet configurations that ship with Single Hinge Doors are hinged on the left side by default.
With single hinge door removed, remove (2) hinge brackets from cabinet frame by removing (2) #10 Phillips screws and (2) #10 lockwashers
from each bracket and slide bracket out of cabinet frame as shown. Invert brackets so that bottom-left bracket becomes top-right bracket and
top-left bracket becomes bottom-right bracket as shown below. Secure brackets to cabinet post with (2) #10 Phillips screws and (2) #10
lockwashers per bracket. Brackets are to be inserted through upper-most opening of cabinet frame.
Reverse door handle orientation by removing cam from door handle assembly and door handle assembly from Single Hinge Door. Rotate door
handle assembly 180º. Rotate orienation of cam stop 90º clockwise while door handle cam and hex bolt are removed from handle assembly.
Reinstall handle assembly into Single Hinge Door. See ‘Door Handle Direction Reversal’ view below. Remove PANDUIT label from bottom of
door and reinstall label centered and 7-1/4” from top of door.
#10 Phillips Screws and
#10 lockwashers
(Remove and use to install
hinge bracket on opposite
side of cabine frame)
Hinge Bracket
(Tab is to be inserted
into cabinet frame)
Hinge Bracket Installation and Removal
Door Handle Direction Reversal
FRONT OF CABINET
Remove Hinge Brackets
(See detail view)
Reinstall Hinge Brackets on
Right Cabinet Post
(Hinge point to be orientated
towards outside of cabinet)
Remove Door Handle Cam
and Hex Bolt
Remove Phillips Screw and Bridge Bar
Remove Door Handle, Rotate 180º, and Reinstall Handle
Reinstall Door Handle Cam
and Hex Bolt
Reinstall Phillips Screw and Bridge Bar
Rotate Orientation of Cam
Stop 90º Clockwise
(This allows for door
handle to swing in
proper direction)
