INSTRUCTIONS CM281G
For instuctions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maitain.asp
E-mail:
cs@panduit.com
Fax
(708)444-6448
www.panduit.com
Page 4 of 4
1. Use 3/8”-16x1” bolt, 3/8”-16 nut and 3/8” lockwasher provided with
N
ET
F
RAME
to gang two racks
together using
N
ET
F
RAME
junction holes located on side of rack channels.
2. Straddling the two racks, fasten Top Bracket and Bottom Bracket with #10-32x5/16” screws provided.
3. Door installs to top and bottom brackets by aligning lower hinge pin to hinge pin mounting hole.
Squeeze knobs together, then align upper hinge pin to upper hinge pin mounting hole. Release pressure
on knobs to set door in place.
Top
Bottom Bracket
NFD884
NFD484
installed to
N
ET
F
RAME
with
(4) #10x32 screws provided.
Door Installation
NFD484
NFEDB23
NFEDB23
installed to
N
ET
F
RAME
Top Flange
with #10-32 screws
provided. To be used
when rack is set-up for
23” mounting
Center Door
NFD884
NFD1284
NFSK
attaches to
rack with (2) #12-24
screws provided
Spool
NFSK