INSTRUCTIONS CM698
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 3 of 4
Step 2: Door Removal and Installation
2.1 Use key to turn lock 1/4 turn
2.2 Pull top of door away from enclosure
3.3 Lift door up and away from enclosure
3.4 Reverse steps to install door
1/4 Turn Lock
Step 3: Optional Fan Installation (if required, sold separately)
3.1 Break out vent space on bottom of enclosure.
3.2 Place fan over opening. Line up the bottom fan
cover to the outside of enclosure and screw
into place.
3.3 Line up top fan cover and screw into place.
3.4 Determine the length of the power cord that is
desired. Strip back the insulation on the cord
and terminate to the plug.
3.5 Attach the power cord. The fan can be plugged
into an the electrical box inside the enclosure.
Break out
vent space
Step 4: Optional Back Plate Installation (PZBASE3E ONLY, sold separately)
4.1 Position Back Plate (p/n PZBASE3EBP -or-
PZBASE3EPBP) inside PZBASE3E enclosure.
4.2 Secure Back Plate to enclosure with [4] M5
Serrated Hex Nuts (use 8mm socket wrench).
[4] M5 Serrated Hex Nuts
(use 8mm socket wrench)
PZBASE3EBP
-or-
PZBASE3EPBP
PZBASE3E ONLY
