INSTRUCTIONS CM315
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 2 of 4
P
AN
Z
ONE
Wall Mount Cabinets can be installed in a hinged right or hinged left
application. For your installation, determine which side of the cabinet will hinge.
The cabinet is shown hinged right. Rotate the cabinet 180 degrees for the left
hinge application. Mounting surface must have sufficient strength to support
the cabinet with payload. The mounting surface must also be flat and extend
beyond the overall cabinet footprint.
Step 1:
Install (4) 3/8” mounting hardware (not provided) as shown in Location
Footprint. Hardware should protrude 3/8” from wall. Mount the cabinet
to the wall by hooking the keyholes over the protruding 3/8” mounting
hardware. Once the cabinet is in place, carefully swing cabinet from
wall and tighten the hardware securely.
Front Door
with Lock
7/8” Conduit Knockout
7/8” or 1 1/8” Conduit Knockout
Wireless Access
Point Knockouts
2” or 3” Conduit Knockout
2” Conduit
Knockout
Step 2:
Install door by pressing(2) hinges provided in locations shown below.
Door Hinges
Step 3:To adjust the depth of the mounting rail for specific
applications, remove the mounting screws and lockwashers,
move the rail to the desired position and re-install mounting
hardware.
Mounting Rail
Mounting Hardware