INSTRUCTIONS CM378
For instuctions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail:
cs@panduit.com
Fax
:
(708)444-6448
www.panduit.com
Page 2 of 2
2.1. Align following components over located hole as shown in enclosure door: (1) #12 External Tooth Lockwasher,
(1) Grounding Bracket, and (1) #10 Split Lock Washer. Fasten with (1) #10-32 Thread Forming Screw. See
Figure 2.1.
Installation: Bracket
Figure 2.1
#10-32 Thread Forming
Screw
#10 Split Lock Washer
#12 External Tooth
Grounding Bracket
Enclosure Door
Installation: Door and Equipment Jumpers
3.1. Install 90-degree lug of door jumper to grounding bracket and secure with (1) #12-24 screw. See
Figure 3.1.
3.2. Install flat end of door jumper to one of the bonding studs and secure with (1) #10-32 nut.
See Figure 3.2.
3.3 Install 1-hole lugs of (2) equipment jumpers to grounding bracket and secure with (2) #12-24 screws. See
Figure 3.3.
3.4 Install 2-hole lugs of equipment jumpers to (2) switches and fasten with provided screws. See
Figure 3.4.
Figure 3.2
Figure 3.3
Figure 3.4
Figure 3.1
