INSTRUCTIONS CM372
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 3 of 8
2.1 Install Ceiling Mount Brackets against side wall of the enclosure
with the flanged edge facing away from the enclosure. (see figure
2) The top of the flanged edge should be even with the enclosure
door.
2.2 Fasten the bracket to the base of the enclosure using four of the
supplied #6-32 Screws.
2.3 Repeat steps for remaining 3 Ceiling Mount Brackets.
Step 2: Install In-Ceiling Frame Style Brackets
3.1 When the enclosure will be mounted in a suspended ceiling, a
rectangular hole that is approximately
12 7/8” x 14 5/8”
must
be cut in the ceiling tile.
3.2 It is important that the hole be no smaller than 12 5/8” x 14 3/8”
and no larger than 13 1/8” x 14 7/8”. This will ease installation
and prevent visible gaps around the enclosure once installed.
Note:
The bottom edges of the assembled enclosure brackets can be
used as a guide to trace the square hole size onto the ceiling
tile.
Step 3: Prepare Ceiling Tile
2
Longer Brackets
12.9"
14.6"
12.9"
14.6"
3
Option A
Option B
Step 4: Install In-Ceiling 2’ X 2’ Style Bracket
4.1 Insert enclosure into bracket as shown by aligning the
enclosure’s hinge with the hinge slots in the ceiling bracket.
4.2 Secure the four sides of the enclosure to the bracket with
(4) #6-32 screws provided with the bracket as shown.
4.1
4.2
Hinge
Hinge Slot
