INSTRUCTIONS CM372
For Technical Support: www.panduit.com/resources/install_maintain.asp
Step 7: Cisco Aironet 1250 Series Access Point Installation
1. Remove the bracket attached to the back of the wireless access point by removing the (2) #4-40 screws, as shown in
Figure 7.1
2. Install the wireless access point by sliding the four legs down and to the right on the mounting bracket as shown in
Figure 7.2
and a closer view in
Figure 7.3
.
3. Re-attach the bracket removed in step 1 to the mounting bracket with the same #4-40 hardware. This will secure the
wireless access point in place, as shown in
Figure 7.4
Page 5 of 8
7.1
Remove bracket on back side of wireless access point.
7.2
Slide access point feet into mount plate slots
7.3
7.4
Attach the same bracket to the mounting bracket using
the same (2) #4-40 screws.
#4-40
Screws
#4-40
Screws
Mounting Bracket