INSTRUCTIONS CM372
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 7 of 8
Antenna Installation
1. Remove all of the knockout geometry on the enclosure’s door before installing the antenna assembly. Make sure to
knockout the smaller holes to allow access for hardware. Next, feed the antenna wire through the designated knock-
outs and slide the antenna assembly to the left clipping them into place. From the inside of the enclosure, align the
knockout holes for the hardware and attach the antennas to the door using the designated hardware.
Install the screws supplied with
the antennas here to attach
them to the enclosure.
2. The final step is to attach the
antenna wires to the wireless
access point. Correspond the rated
GHz frequency antenna wires with
their designated location. Attach
all wires to their proper locations,
similar to the image on the right.
2.4 GHz
5 GHz
Tak Ty