INSTRUCTIONS CM315E
For Technical Support: www.panduit.com/resources/install_maintain.asp
Kit Contents
•
Combination locks (2)
•
Spacer rings (2)
•
Cylinder nuts (2)
•
Retaining screw (2)
•
Lock washers (2)
•
Flat washers (2)
•
Direction setting washers (2)
Cam Lock Spacer
Rings
Combination locks
including Cylinder Nut,
Retaining Screw, Lock
Washer, Flat Washer and
Direction Setting Washer
Figure 1
Cam Lock Spacer
Rings
Combination locks
including Cylinder Nut,
Retaining Screw, Lock
Washer, Flat Washer and
Direction Setting Washer
Figure 1
.640
.650
.755
.765
DIA.
Mounting Cutout
Installation
•
Remove the existing locks from the cabinet and save
cams for later use. (Figure 2)
•
Remove the Cylinder Nut from the Combination Lock
and insert the Spacer Ring over the Lock Cylinder.
(Figure 3)
•
Install the Combination Lock onto the Cabinet and
tighten the Cylinder Nut. The Lock Head should be
spaced away from the Cabinet Surface. (Figures 3 &
4)
•
Remove the Retaining Screw, Lock Washer, Flat
Washer, and Direction Setting Washer.
•
Pull the Lock Head from the cylinder and rotate until
oriented in the desired direction. (Figures 5-7)
Figure 2
Cam
from
lock
Figure 3
Cylinder Nut
Spacer Ring
Combination Lock Head
PZWMC* Cabinet
Surface
Lock
Cylinder
Cylinder Nut
Installed on
Back of Cabinet
Figure 4
Figure 5
Spacer RIng
Lock
Head
Figure 6
Cam will
rotate
right
Cam will
rotate left
Direction Setting Washer
Figure 7
Page 8 of 11
P
AN
Z
ONE
Lock Kits (PZWMC-CL)
